M4 APP
Not connected
RPM
—
Speed
—
mph
Boost
—
psi
Warm-up
—
Connect to see engine temps.
Not recording

Records everything on the Gauges tab. For a dyno pull: 3rd gear, flat straight road, full throttle from about 2,500 rpm to the shift light, then open the Dyno tab. Do it on a track or closed road.

Saved logs

No pulls found yet. Record a 3rd-gear, full-throttle run from about 2,500 rpm to redline, or make a demo pull to see how it works.

Car for the maths

These are wheel numbers estimated from how fast the car gains speed, so expect them to land within 5–10% of a real chassis dyno. They're best for before/after comparisons on the same road. Weight matters most: every 50 kg is about 3%.

Units

Speed
Temperature
Boost
Power

Shift light

Gearbox

Used to name the gear of a pull

Demo

A simulated stock M4 that warms up, pulls away and does a 3rd-gear pull on a loop. Handy for trying everything without the car.

iPhone setup

  1. Install Bluefy – Web BLE Browser from the App Store (Safari can't use Bluetooth).
  2. Open this page in Bluefy.
  3. Plug the CX into the OBD port (under the dash, driver's side). Ignition on.
  4. Close BimmerCode and BimmerLink so they let go of the adapter.
  5. Tap Connect and choose OBDLink CX. If iOS asks to pair, tap Pair.
  6. Keep the screen on and the app in front while logging.

Can't see the adapter? Show all Bluetooth devices

Adapter

Status
Not connected
Adapter log

Data

Logs are stored only on this phone, in this browser. Export the ones you want to keep from the Log tab.

Read-only: this app only asks the car for standard OBD-II data.
It never codes, flashes or clears anything.
Unofficial, not affiliated with BMW.